TOOL USE
11
INSTALLING THE EXTENSION POLE
To prepare the screwgun for using the extension pole:
1. Remove the nose cone.
2. Remove bit holder assembly.
3. Attach adapter. (See page 7-8 for details.)
4. Tighten set screws. (See page 7-8 for details.)
5. Remove the extension pole drive shaft from inside the extension pole, and insert it into the tool.
Push it in until you hear it snap into place.
6. Slide the extension pole shell down onto the drive shaft.
Thread the extension pole on to the adapter until it’s all the way down and hand-tight.
7. The handle should slide over and down the pole. Place the collar over the bottom of extension pole
just above the adapter. Tighten by spinning the handle clockwise in the desired orientation. (Do not
overtighten).
8. Insert the bit into the end of the extension pole.
9. Slide the attachment down over the top of the bit. Pull it on tight, making sure there’s no gap.
10. Tighten clamp. Adjust the screw if necessary to provide more or less clamping force. This should
be tight enough to prohibit the attachment from easily rotating on the adapter or sliding off with
minimal force.
11. Set nosepiece for the length of screws to be driven. (See Adjusting Fastener Length, on page 8)
12. Set depth of drive for the desired amount of countersink. (See Adjusting Depth of Drive on page 9)
The attachment is now installed and you are ready to load in a screw strip and begin driving screws.
Load the tool and drive screws as described on page 9.
