Additional Safety Warnings
To prevent eye injuries, always wear OSHA required “Z87” safety glasses with per-
manently attached rigid, hard plastic side shields. These safety glasses must have
“Z87” printed or stamped on them. Be sure everyone in your work area is wearing
the same type of safety glasses.
DANGER:
The Fusion tool is charged with compressed air in a sealed chamber. Prior to any
service or repair, release the charge of pressurized gas.
The pressurized air must be released prior to service. Major components such as
the piston/driver assembly, gearbox, piston stop and guide body are all part of the
drive assembly.
Deliberate tampering with the drive assembly may result in the release of the
driver.
Any repair or upgrade requiring access to the pressure chamber may be handled
by an authorized Senco dealer or service center.
Disconnect tool from battery when:
• Outside of the operator’s supervision or control.
• Performing maintenance or repair
• Clearing a jam
• Moving the tool to a new location
With battery disconnected, make daily inspection to assure free movement of workpiece contact element and
trigger. Do not use tool if workpiece contact element or trigger sticks or binds.
Always remove finger from trigger when not driving fasteners. Never carry the tool with finger on or under
trigger. Tool will eject a fastener if the workpiece contact element is bumped and the trigger is pulled.
Drive fasteners into work surface only; never into materials too hard to penetrate.
Do not drive fasteners on top of other fasteners or with the tool at too steep of an angle; the fasteners can
ricochet and hurt someone.
When using tool, care should be taken due to possibility of tool recoil after a fastener is driven. If workpiece
contact element is unintentionally allowed to re-contact work surface following a recoil, an unwanted fastener
may be driven. Therefore, allow tool to recoil completely off work surface after a fastener is driven to avoid this
condition. Do not push workpiece contact element on work surface until a second fastener is desired.
Please review triggering options.
Do not drive fasteners close to the edge of the work surface. The workpiece is likely to split and the fastener
could fly or ricochet and hit someone.
Never use any part of the tool (i.e., the cap or mainbody ) as a hammer. The tool may
activate or become damaged and result in an unsafe condition.
SAFETY WARNINGS
7
Summary of Contents for Fusion F-15XP
Page 24: ......
