11
TOOL USE
1
2
3
CLEARING JAMS:
Should a fastener jam occur, disconnect air supply.
➀
Release the feeder shoe and slide it forward.
➁
Remove fasteners from tool.
③
Remove the bracket screw at the back of the tool and remove the magazine.
1
2
3
Clear jammed fastener from guide body.
Reattach the magazine and fasten magazine mounting bracket screw.
Connect air supply and replace fasteners. Pull feeder shoe back.
The deflector can be rotated to 3 positions to change the direction of the exhaust air.
Disconnect air supply, loosen cap screw with a hex wrench, and then rotate deflector to
desired direction.
Prior to tool use, ensure deflector cap screw is tightened.
This tool is equipped with a lockout feature:
When approximately five nails remain in the magazine, the workpiece contact (safety element) will be locked in the
undepressed position until more nails are loaded into the magazine.
Repairs other than those described here should be performed only by trained, qualified personnel. Contact SENCO for
information at 1-800-543-4596.
Read section titled “Safety Warnings” before maintaining tool.
