9-ENG
D22235
Before you store the air compressor, make sure you do
the following:
1. Review the "Maintenance" section on the preceding
pages and perform maintenance as necessary. Be
sure to drain water form the air tank.
2. Protect the electrical cord and air hose from damage
(such as being stepped on or run over). Wind them
loosely around the compressor handle and shroud.
Store the air compressor in a clean and dry location.
STORAGE
1. Before attaching air hose or accessories, make sure
the OFF/AUTO lever is set to "OFF" and the air
regulator is closed. (Close by turning it counterclock-
wise.)
2. Attach hose and accessories.
INCORRECT USE CAN CAUSE BURSTING,
FIRE OR EXPLOSION HAZARDS. CAREFULLY
FOLLOW STEPS 3, 5 AND 6 EACH TIME THE
COMPRESSOR IS USED.
3. Check the manufacturer's maximum pressure rating
for air tools and accessories. The regulator outlet
pressure must never exceed the maximum pressure
rating.
4. Turn the OFF/AUTO lever to "AUTO" and allow tank
pressure to build. Motor will stop when tank pressure
reaches "cut-out" pressure.
5. Open the regulator by turning it clockwise. Adjust the
regulator to the correct pressure setting. Your com-
pressor is ready for use.
6. Always operate the air compressor in well-ventilated
areas, free of gasoline, flammable paint or solvent
vapors. Do not operate the compressor near the
spray area.
OPERATING PROCEDURES
• When you are finished:
7. Set the "OFF/AUTO" lever to "OFF".
8. Turn the regulator counterclockwise and set the
outlet pressure to zero.
9. Remove the air tool or accessory.
10. Open the regulator and allow the air to slowly bleed
from the tank. Close the regulator when tank pres-
sure is approximately 20 psi.
11. Drain water from air tank.
WATER WILL CONDENSE IN THE AIR TANK.
IF NOT DRAINED, WATER WILL CORRODE
AND WEAKEN THE AIR TANK CAUSING A
RISK OF AIR TANK RUPTURE.
With tank pressure at approximately 20 PSI, open the
drain valve and tip the outfit allowing all the moisture
to drain.
NOTE
If drain valve is plugged, release all air pressure.
The valve can then be removed, cleaned, then
reinstalled.
12. After the water has been drained, close the drain
valve. The air compressor can now be stored.
Summary of Contents for TURBO HOT DOG DAC-7128-2
Page 13: ...13 ENG D22235 REPAIR PARTS...
Page 14: ...14 ENG D22235 AIR COMPRESSOR DIAGRAM...
Page 31: ...13 FR D22235 LISTE DE PI CES...