ENAMEL RATER MANUAL: V.10
13
2.5
SWITCHING ON AND THE SELF TEST
Having satisfied yourself that the mains voltage setting is correct,
connect the mains plug to a suitable socket outlet or if you prefer
wire the mains cable directly into a fused outlet. Switch on the
by depressing the mains on/off switch on the back panel.
On power up, the system will perform a self-test. The numeric
displays will cycle through each digit from 0 through to 9 allowing
the operator to see that all the segments illuminate correctly. The
LED indicators will be illuminated in sequence.
Finally the will go to standby mode with the can number
and timer set to zero and the milliamp display set to dashes.
Enamel rating can then begin by pressing.
i.
The start key.
Enamel rating will start when the level and
contact check requirements are satisfied (indicators off)
and continue for 4 seconds.
ii.
The Free Run key.
The will enamel rate for up
to 99 seconds in free run.
iii.
The Reverse Polarity key.
As ii) but with reversed
polarity (can body negative)
