EN 7
EN
Revision 05/2021
Copyright © 2021, Fast ČR, a. s.
When connected to the car ignition key, the unit turns on and starts recording when
the key is turned to the “Accessories” position, and stops recording and turns off
when the ignition key is turned off. When the battery is charged and only the unit
operation is active, the red charging indicator will go out. The entire charging process
of a fully discharged battery takes up to 180 minutes. The camera built-in battery
serves only as a buffer to bridge transient power states and does not prolong the
camera operation with no power connected.
2.3. USB modes
When connecting with a USB cable to a PC and turning on the device, in addition
to charging, a menu with a selection of 3 options will appear. Please select one of
the following:
1) Mass Storage - files on the card inserted in the unit can be only read from PC
until the cable is disconnected. The unit cannot be controlled with the buttons
except for powering off. The files are stored by date in the DCIM folder.
2) Recording mode - a common function, only power is used.
2.4. Putting into operation, recording
1. Connect the power supply, long (5s) press the On/Off button to turn it on and
adjust to your taste as described later in this manual. After the initial procedure,
press the On/Off button for a longer time (up to 3s) to switch off the device.
2. Place the camera with the mount in a suitable place on the car glass, connect
the power and turn on the camera manually or connect it to a switched power
supply for automatic switching.
2.5. Operating modes and their use
Switching the operating modes with the MODE button
1. Press On/Off to turn on the device, the blue status indicator lights up and
after the splash screen, the operation screen with status icons and indicators
will appear. If power is connected (e.g. in a car), the camera starts recording
immediately, in which case stop it by pressing REC/OK button.
