Hair Clipper
SHP 3301BL / SHP 3302RD / SHP 4301BL / SHP 4302RD
EN
EN-9
2016
05/2016
•
Clean out the body of the hair clipper A
3
and the comb attachment A
2
with a clean dry cloth. In
the event that it is very dirty, you can use a lightly dampened cloth. Then wipe everything so that
it is thoroughly dry.
•
To clean the adapter A
8
, use a clean, dry cloth.
•
Do not use abrasive cleaning products, thinners, solvents, etc. for cleaning.
LUBRICATING THE CUTTING UNIT
•
We recommend that the cutting unit A
1
is lubricated after every use after it has been cleaned out.
•
Remove the cutting unit A
1
from the body of the hair clipper as described in the Cleaning sub-chapter.
•
Apply two to three drops of oil A
0
between the cutting teeth and smear evenly. Wipe off excess
oil using a clean, dry cloth.
D
•
When all the supplied oil A
0
has been used up, use an oil that does not contain acids (e.g. sewing
machine oil).
•
Reattach the cutting unit A
1
back onto the body of the hair clipper A
3
as described in the
Cleaning sub-chapter.
LIFETIME AND REPLACEMENT OF THE CUTTING UNIT
•
The cutting unit A
1
must be replaced once every two years, under the assumption that the hair
clipper is used approximately four times per month for a duration of 20 minutes, or sooner when it
shows signs of wear or is damaged in any way.
•
Please contact an authorised service centre to order a replacement cutting unit A
1
.
