EN-6
EN
Milk Frother and Warmer
SMF 2020WH
2018
11/2018
BEFORE FIRST USE
1) Take the appliance and its accessories out of the packaging materials.
2) Before
fi rst use, wipe the inside of the kettle A
2
using a cloth dampened in a solution of warm
water and neutral kitchen detergent. Use a cloth dampened in warm water to thoroughly wipe the
surface on to which you applied the kitchen detergent and then wipe it dry.
3) Wash attachments A
7
–
8
and lid A
1
in warm water using a neutral kitchen detergent. Then rinse
these parts under running water and dry them.
4) Now the appliance is ready for frothing and heating milk.
USING THE MILK FROTHER AND WARMER
1) Unwind the power cord and place the base A
5
on a stable, even and clean surface.
2) Select an attachment A
7
or A
8
depending on the operating mode and attach it to the shaft
located inside the kettle A
2
.
The frothing attachment A
7
is designed for the milk frothing and heating mode or the milk
frothing mode without heating. The stirring attachment A
8
is designed for the milk heating mode
without frothing.
3) Pour well cooled milk into the kettle A
2
while following the instructions described below.
If you wish to use the milk frothing and heating mode or the frothing mode without heating, the
milk level must not exceed the bottom level mark (100 ml), that is marked on the inside wall of the
kettle A
2
.
If you wish to use the milk heating mode without frothing, the milk level must not exceed the top
level mark (200 ml), that is marked on the inside wall of the kettle A
2
.
Attention:
Do not fi ll the kettle A
2
when it is placed on the base A
5
.
If the kettle A
2
is overfi lled, milk may splash out during operation.
Tip:
For creating milk froth, use milk with a higher fat content, ideally full-cream milk (fat content
of 3.5 %).
4) Place the kettle A
2
on to the base A
5
. Insert the power plug into an electrical power socket.
When the power cord is inserted the indicator light A
3
will be lit red.
5) Set the operating mode that corresponds to the attachment inserted in the kettle A
2
.