EN - 10
Troubleshooting
If a fault occurs,
fi
rst check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following hints, consult your dealer or service center.
Note: Do not open the unit as there is a risk of electric shock. Under no circumstances should you
try to repair the set yourself; as this will invalidate the guarantee.
No power
•
Ensure that the power cord connect securely.
•
Ensure that there is power at the AC Mains.
•
Ensure that the batteries are inserted correctly.
No sound or poor sound
•
Adjust the volume.
No response from the unit
•
Disconnect and reconnect the AC power cord, then turn on the unit again.
•
Electrostatic discharge, re-connect the AC power cord after a few seconds.
CD does not play
•
The disc is dirty. Clean the CD.
•
The disc is placed upside down. Remove and place the CD right side up.
• Use
a
fi
nalized CD or correct format disc.
The CD skips tracks
•
Ensure that the CD is not damaged or dirty.
•
Ensure that program mode is deactivated.
Poor radio reception
•
Electrical interference in your home can cause poor reception. Move the unit away from them
(especially those with motors and transformers).
•
Fully extend the telescopic antenna.
The unit does not function properly while using batteries
•
Batteries are dead. Replace the new batteries.
•
The polarities of the batteries are incorrectly positioned.
•
Reinsert the batteries ensuring the polarities (+/-) match the unit’s indicated polarities (+/-).
File from MP3 disc does not play
• Check
the
fi
le format. This product only support MP3 format.
Remarks:
•
If the unit is not used for 30 minutes or more, it will automatically enter
STANDBY
mode.
Press the
PROGRAM/RESTART
button to resume use.
•
If any anomaly occurs, switch the
FUNCTION Selector
to
OFF
position, and then switch it
back to
CD/MP3
or
FM ST.
position again.
Summary of Contents for SPT 226
Page 2: ......
Page 15: ...EN 13 ...