05/2017
- 3 -
Copyright © 2017, Fast ČR, a.s.
■
In the event that an item, such as a spoon, falls into the bowl during operation,
immediately set the speed control knob to the OFF position (stand-by mode), and
disconnect the power cord from the power socket. Wait until the rotating parts
come to a stop and then remove the item.
■
If ingredients stick to the attachment or the sides of the bowl, turn the appliance
off, disconnect it from the power socket, and wait until the rotating parts come to
a stop. Use a silicone spatula to clean the attachment and the inside of the bowl.
Then you can restart the appliance.
■
Make sure that no hair, clothing or other items enter the feed tube of meat grinder
while it is running. Do not put anything other than the ingredients that are to be
processed into the feed tube.
■
Never use your fingers or other items to push ingredients through the meat grinder
feed tube. For this purpose there is a pusher included as an accessory.
Warning:
Incorrect use may lead to injuries.
■
To prevent injury caused by sharp edges, be especially careful when handling
the grinding blade of the meat grinder and the blade assembly of the blender.
Increased attention must also be paid when emptying out the blending jar, when
removing the blade assembly from the blending jar, when removing the grinding
blade from the chamber, and when cleaning the appliance.
■
Do not attempt to grind bones, nut shells or other hard ingredients.
■
Hot liquids up to a temperature of 80 °C may be processed in the blending
jar. Be especially careful when handling hot liquids. Hot steam or splashing hot
foods and liquids may cause scalding. Never start the blender without the lid
properly seated in position. When processing hot liquids, do not remove the inner
cap during operation. Do not touch the hot surface. Use the handle to carry the
blending jar when it is hot.
■
The maximum continuous operating time is 10 minutes. Do not exceed the
maximum operating time of 5 minutes when in the kneading mode and do not
exceed the maximum operating time of 2 minutes when using the blender. Before
starting it again, allow the appliance to cool down for 30 minutes.
■
Always turn off the appliance, disconnect it from the power socket when
not be using it, when leaving it without supervision, and before assembling,
disassembling, cleaning or moving it. Prior to disassembling the appliance and
replacing accessories or accessible parts that move during use, wait until all
moving parts come to a stop.
■
Clean it according to the instructions in chapter Cleaning and maintenance.
■
Never wash the appliance under running water or submerge it in water or another
liquid.
