Electric Kettle
SWK 1780
EN
EN-5
05/2011
BEFORE FIRST USE
1. Remove all wrapping material from the kettle and its base.
2. Fill the kettle with clean water up to the maximum water level indicator. Boil the water and empty
the contents of the kettle. Repeat this process 2 to 3 times.
Note
:
To boil water in the kettle proceed according to the instructions in chapter Using the kettle.
3. Now the kettle is ready for use and for preparing warm beverages, etc.
USING THE KETTLE
1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place
the base on a stable, even and clean surface.
2. Fill the kettle with the required amount of water. You may fi ll the kettle through the spout or
through the opening after lifting the lid.
Attention:
Do not fi ll the kettle with less than 0.5 l of water or more than 1.7 l of water. The maximum
water level indicator is located inside the kettle.
Warning!
Never fi ll the kettle if it is located on the base.
If the kettle is overfi lled, then boiling water could splash out.
3. Place the kettle on the base. Insert the power plug into the an electrical power socket. Check that
the lid of the kettle is closed.
4. Put the kettle into operation by moving the switch to the ON position. The power On light will
illuminate.
Attention:
Do not turn on the kettle if it is empty. The incorrect use of the kettle may negatively affect its
lifetime. If you accidentally turn on the kettle without water, the thermostat will, after reaching
a certain temperature, interrupt the electric circuit. The switch will move to the OFF position and
the indicator light will turn off. The kettle can be used again after several minutes, as soon as its
stainless steel bottom has cooled down.
5. As soon as water boils the kettle will turn off automatically and the power On light will turn
off. Before taking the kettle off the base, check that it has turned itself off automatically.
If the kettle does not turn itself off automatically, turn the kettle off manually by moving the switch
to the OFF position.
Note:
The operation of the kettle can be interrupted at any time by moving the switch to the OFF
position.
6. Pour the boiled water into a prepared container, cup or mug. Ensure that when carrying the kettle
it remains in a horizontal position, especially when fi lled with the maximum amount of water.
If you wish to open the lid to refi ll the kettle, fi rst empty all the contents from the kettle so that
you are not scalded by the escaping steam.
7. After
you
fi nish using the kettle, disconnect the power cord from the el. power socket. Empty the
kettle and allow it to cool down.
