USER MANUAL – Z-GPRS2 / Z-LOGGER
51
15.4.
"ZERO COST" RING COMMANDS (Z-GPRS2
ONLY)
Z-GPRS2 lets you run up to 3 actions tied to a ring from a classified number (thus from an operator
or administrator).
This mode lets you run "zero cost" commands.
NOTE
-To keep zero cost for Z-GPRS2, DO NOT answer the call! The phone will ring for about 40
seconds after which Z-GPRS2 automatically hangs up.
-Not all mobile service providers let you receive rings from data SIM. Check whether the service
is offered by your provider.
15.5.
COMMAND PASSWORD (Z-GPRS2 ONLY)
Z-GPRS2 lets you run SMS commands even if the command is not sent by a number in the address
book. For the number to be recognised as authorised, the command must be preceded by a
numeric password, univocal to each Z-GPRS2.
The password is obtained from the last 4 numbers in the GSM modem IMEI code.
You can find your Z-GPRS2 password in the test configuration section in the Easy Setup / Easy Z-
GPRS2/Z-Logger software.
The secret password, always made up of 4 numbers, will be displayed in this section.
If, for example, the password is 5287, the digital output can be closed by a number not in the
address book by sending the following SMS:
5287 SET DOUT1.CLOSE
Summary of Contents for Z-GPRS2
Page 8: ...MANUALE UTENTE Z GPRS2 Z LOGGER 8...
Page 72: ...MANUALE UTENTE Z GPRS2 Z LOGGER 72...
Page 165: ...USER MANUAL Z GPRS2 Z LOGGER 73...
