ENGLISH - 4/8
t
RS485
A
RS485
B
RS485
GND
IDC10
Power supply
AC-
Power supply
AC+
B
A
Don’t turn upside down
don’t force the insertion
the module and
o
into
f the IDC10 connector
the
Z-PC-DIN bus. The IDC10 connector located on the rear of the module will be inserted on a free slot
of Z-PC-DIN accessory. In the figure you can see the meaning of the various pins of the rear IDC10
connector if you want to provide the signals directly through this connector. The pictures
and
Fig. 1 c
Fig.1 d
show how to connect powersupply and RS485 COM1 port to the rear IDC10 connector.
USE OF Z-PC-DINAL ACCESSORY
Insertion on the IEC EN 60715 DIN rail:
1) Move the two hooks on the back of the module
outwards as illustrated in fig. 1b.
2) Insert the module rear IDC10 connector into a free
slot of DIN rail accessory as you can see in fig 1a.
(the insertion is one way only because the connectors
are polarized).
3) To secure the module to the IEC EN 60715 DIN rail,
tighten the two hooks on the side of the IDC10 rear
connector as shown in fig. 1a.
Removal from IEC EN 60715 DIN rail:
As shown in fig. 1b:
1) Move outwards the two hooks on the side of the
module, with the help of a screwdriver.
2) Extract the module from the IEC EN 60715 DIN rail.
INSTALLATION ON AND REMOVAL FROM IEC EN 60715 DIN RAIL
Fig. 1a
20 21
19
23 24
22
11 12
10
D 4
I
D 3
I
D 2
I
DI1
ETH
LNK
ETH
ACT
SD
PWR
ETHERNET
GSM
485
ACT
DO2
D 1
O
ANTENNA
Z-GPRS3
19 20 21
22 23 24
micro
USB
10 11 12
13 14 15
16 17 18
1 2 3
4 5 6
S
SENECA
Fig. 1b
20 21
19
23 24
22
11 12
10
D 4
I
D 3
I
D 2
I
DI1
ETH
LNK
ETH
ACT
SD
PWR
ETHERNET
GSM
485
ACT
DO2
D 1
O
ANTENNA
Z-GPRS3
19 20 21
22 23 24
micro
USB
10 11 12
13 14 15
16 17 18
1 2 3
4 5 6
S
SENECA
