ENGLISH -
6/8
t
19 20 21
22 23 24
USB
10 11 12
13 14 15
16 17 18
1
2
4
5
6
10 11 12
22 23 24
19 20 21
3
19 20 21
22 23 24
microUSB
10 11 12
13 14 15
16 17 18
1
2
3
4
5
6
10 11 12
22 23 24
19 20 21
Insertion on the IEC EN 60715 DIN rail:
1) Move the two hooks on the back of the module
outwards as shown in fig. 1b.
2) Insert the module rear IDC10 connector into a free
slot of the DIN rail accessory as shown in fig 1a.
(the insertion is only possible in one direction because
the connectors are polarized).
3) To secure the module to the IEC EN 60715 DIN rail,
tighten the two hooks on the side of the IDC10 rear
connector as shown in fig. 1a.
Removal from IEC EN 60715 DIN rail:
As shown in fig. 1b:
1) Using a screwdriver, move the two hooks on the side
of the module outwards.
2) Carefully extract the module from the
IEC EN 60715 DIN rail.
INSTALLATION ON AND REMOVAL FROM IEC EN 60715 DIN RAIL
WARNING: Before performing any operation it is mandatory to read the full contents
of this manual.
The module may only be used by qualified and skilled electric installation
technicians. Specific documentation is available for download at website:
www.seneca.it/products/z- .
lte
The symbol
with the word
!
WARNING
identifies conditions and actions that pose hazard(s) to
the user
identifies conditions and actions that may
. The symbol
with the word
!
CAUTION
damage the device or the equipements connected.
The warranty is void in case of faults resulting from improper use, from modifications or repairs
carried out on the device without the authorisation of the Manufacturer, or if the instructions of this
user Manual are not followed.
Only the Manufacturer is authorized to repair the module or to replace damaged parts.
The product is susceptible to electrostatic discharge, take appropriate countermeasures
use
during
.
CAUTION: It is forbidden obstruct the ventilation slits in any way.
It is forbidden to install the module near heat sources.
Disposal of electrical & electronic equipment (applicable within the EU and other
countries implementing sorted waste disposal procedures).
found on this product
The symbol
or on its packaging indicates that this product it must be handed over to an authorised
,
collection point for
the recycling of electrical and electronic
equipments.
PRELIMINARY WARNINGS
