11
WWW.SENIXTOOLS.COM
To avoid serious personal injury, do not wear loose
chains, ties, etc., that could get drawn into the air vents.
To make sure long hair does not get drawn into the air
vents, tie back long hair.
power switch to the OFF (0) position and unplugging the
unit from the main power source.
Do not use in vacuum/mulcher mode without the
vacuum tubes and collection bag in place.
To avoid serious personal injury, be sure the unit is OFF
and unplugged before clearing the impeller.
To avoid serious personal injury, always wear gloves to
protect yourself from the impeller blades or other sharp
objects.
During the vacuuming process, certain objects such as
cloth, rope or large diameter sticks may obstruct the fan
and block the motor. A thermal protection device, which
is built into the blower vac, will cut off the electricity to
the motor to prevent damage from overheating.
In the event an obstruction occurs and power is
curtailed:
Never cover air vents. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
handle and the other hand on the auxiliary handle.
Sweep from side to side with the nozzle several inches
Slowly advance the unit, keeping the accumulated pile
of debris in front of you. Most dry blowing operations
are better suited to low speeds rather than high speeds.
High speed blowing is best for moving heavier items like
large debris or gravel.
can convert to vacuum mode to collect the debris.
the bag. Items such as small leaves and twigs will be
mulched as they pass through the fan housing. For
longer bag life and increased performance, empty the
bag frequently
(Fig. 17).
happens, turn the power switch to the OFF (0) position
and unplug the unit from the power supply. Remove
the bag and empty the debris.
(Fig. 11). To empty, hold the plastic handle and grab
the nylon handle on the underside of the bag. Turn
the bag upside down and shake out any debris and
leaves.
AIR VENTS
BLOWER MODE
1. Slide the ON/OFF switch down to the OFF (0)
position until the unit comes to a complete stop.
2. Unplug the unit.
3. Remove the blower tube or vacuum/mulcher tubes
and the bag.
4. Using protective gloves, carefully remove the
material blocking the tube or impeller. Inspect the
blades to ensure no damage has occurred. Rotate
the impeller blades by hand to ensure the blockage is
completely cleared.
5. Reinstall the blower tube or vacuum/mulcher tubes
and the bag.
6. Wait 3 minutes for the motor to cool.
7. Plug the unit back into the power supply and turn
the ON/OFF switch to ON (1). The blower vac will
resume normal function.
Fig. 17
Fig. 16
