background image

2.0mm SMART CLEANER Fiber Optic Cleaner

www.senko.com

Best Cleaning Results For Plugs:

Best Cleaning Results For Jacks:

1

1

1

2

2

2

3

4

3

3

Open cover on red end cap

Hold cleaner towards the rear keeping 
finger tips located on the ridges

Push forward until audible click 

1

2

3

4

Place red end cap on back of handle

Hold cleaner towards the rear keeping 
finger tips located on the ridges

Insert cleaning tip into the jack

Push forward until audible click 

Cleaning Plug & Jack

Summary of Contents for SCK-SS-M-200

Page 1: ... access connectors in confined spaces Rotating cleaning tip uses a sweep lift motion for effectively wiping away residues and dust particles No need for sleeve removal tools since cleaning tip works for cleaning both Jack and Plug ends Dissipative barrel prevents static charge generation during cleaning process Cleans 400 endfaces with no need for cleaning solvents P N SCK SS M 200 ...

Page 2: ... 3 3 Open cover on red end cap Hold cleaner towards the rear keeping finger tips located on the ridges Push forward until audible click 1 2 3 4 Place red end cap on back of handle Hold cleaner towards the rear keeping finger tips located on the ridges Insert cleaning tip into the jack Push forward until audible click Cleaning Plug Jack ...

Page 3: ...l Cleaning Performance After one engagement Fine dust particles After one engagement Skin oil residue After one engagement Moisture residue from duster Step 1 Apply contaminate Step 2 Engage cleaner one time Step 3 Check and record image 1 2 3 Test Setup For Cleaning Demonstration ...

Page 4: ...eventing cross contamination If you use canned air dusters in your cleaning regiment always hold the cans upright to prevent the moisture contamination from the air stream Always clean fiber end faces after blowing connectors with canned air dusters to remove dust particles that may have landed on ferrule surface Remember the SMPTE 304M has electrical contacts so take precautionswhenusingsolventst...

Reviews: