4
2.0mm SMART CLEANER Fiber Optic Cleaner
www.senko.com
America
USA EAST 1-888-32-SENKO
USA WEST 1-858-623-3300
TEXAS 1-972-661-9080
Sales-Americas@senko.com
Asia
HONG KONG +852-2121-0516
SH86-21-5830-4513
SH86-755-2533-4893
Sales-Asia@senko.com
Europe
UK +44 (0)1256 700880
ITALY +39 011 839 98 28
48 71 396 36 59
Sales-Europe@senko.com
Asia Pacific
AUS61 (0) 3 9755-7922
Sales-Asia-Pacific@senko.com
Japan
TOKYO +81 (0) 3 5825-0911
Sales-Japan@senko.com
South America
55-21-3736-7065
Sales-Brazil@senko.com
www.senko.com
Tips
• Always clean both ends (plug & jack) just before mating
for preventing cross contamination.
• If you use canned air dusters in your cleaning regiment,
always hold the cans upright
to prevent the moisture
contamination from the air stream.
• Always clean fiber end faces after blowing connectors
with canned air dusters to remove dust particles that may
have landed on ferrule surface.
• Remember the SMPTE 304M has electrical contacts so
take
precautions when using solvents
to avoid shorting the circuit.
• Never look directly at the fiber end faces
unless you
know the signal is off - the wavelength for the optical signal
wavelength is 1100nm to 1350nm
which is beyond visibility
of the human eye.
2.0mm SMART CLEANER Tip
Fiber Optic Ferrule
Low Voltage Electrical Contact
(42V AC or 60V DC with 1A current)
Auxiliary Electrical Contact
(600V AC with 10A current)
View of 2.0mm SMART CLEANER on Plug