6.4 Memory recall
To recall a stored position follow the steps:
1. Shortly press the desired memory button.
2. Memory button will turn green and the gear will reach the stored focus position. (See the picture below)
* To recall the 4
th
position, follow the steps:
1. Press shortly the memory button which is turned on at that moment. No green light should be turned on.
2. When all memory buttons are turned off, 4
th
focus memory position is active. (See the picture)
Recalling the stored focus points
6.5 Recall Speed
The speed of change between different memory positions depends on the position of the
speed recall
potentiometer
. Left end position represents the slowest moving; right end position represents fastest moving.
You can adjust the
recall speed
during your work and the change will apply immediately.
6.6 Remote REC and trigger command
Communication between rec/trigger
sensor and the camera sensor
IMPORTANT! This option will not be available if
you do not connect the REC/trigger sensor with the
receiver, or if the sensor is not properly mounted (See
the charter
mounting the All Recall Focus
)
All Recall Focus
is equipped with Canon remote controller.
To activate the rec/trigger sensor, please follow the steps:
1. Turn your DSLR camera on.
2. Press AF drive
3. Move the cursor to the third option (timer), as it is shown on the
picture
4. Rec/Trigger command is activated.
