3. Mounting the All Recall Focus:
3.1 To mount All Recall Focus properly, please follow the steps:
1.
Attach the rods on the camera plate
2.
Mount your camera on the camera plate
3.
Mount the receiver on the rods (it should be turned to the right, as shown on the picture above)
4.
Mount the IR sensor for REC/trigger command on the left rod so that it stand right in front of the
sensor of your camera, as it is shown in the picture.
5.
Mount the focus motor on the left rod (see the picture above)
6.
Connect the motor with the receiver
7.
Connect the IR sensor with the receiver
8.
Mount the adjustable gear rings on the focus gear on your lens. (Pay attention that the rest of the ring
is turned in the opposite direction from the motor driver)
9.
Make In/Out range calibration (See the charter
In/out range calibration
)
10.
Connect focus gear to your lens’ gear. Pay attention: Motor gear spring must be tensed.
For larger lens, when you need longer rod to mount the focus motor gear, you can attach one rod to
another, like shown in the picture:
