3.5 Motor gear polarity
Motor-gear polarity is set to default.
If you would like to change the direction of motor-gears you should follow the steps:
1.
Keep the transmitter off.
2.
Press and hold the button 3.
3.
While holding
that button 3, switch the transmitter on.
4.
Release the button 3.
5.
Motor polarity has been changed.
IMPORTANT!
When the polarity is changed, the in/out range calibration must be done the opposite way, meaning that
minimum points should be changed with maximum positions and vice versa.
3.5.1
Return to default motor polarity settings:
To return to default motor-gear polarity settings, please follow the steps:
6.
Keep the transmitter off.
7.
Press and hold the button 1.
8.
While holding
that button 1, switch the transmitter on.
9.
Release the button 1.
10.
Motor polarity has been changed to default.
4. Transmitter
After the power switch on the transmitter and receiver is turned ON, transmitter will start establishing
wireless communication with receiver and memory buttons will flash.
When the memory buttons stop flashing, the light on REC button will continue to shine blue. Wireless
communication between transmitter and receiver is now established.
