After
All Recall Focus
receiver
is turned on with a power switch, device will go through a short self-testing
and
signal
and
power
LED indicators will flash twice. After that, both LED indicators will turn on.
If the receiver fails to establish wireless communication, signal LED light will flash fast.
IMPORTANT! If you do not connect focus motors with transmitter, wireless communication cannot be
established.
6) Functions:
6.1 Changing focus
To move the focus gear on your camera lens, use the big potentiometer at the bottom side of the transmitter.
Position and speed of focus change directly correspond to potentiometer movement.
6.3 Focus memory
Follow the steps below to store 4 different positions of focus:
1. Move the
focus potentiometer
at the bottom size of the transmitter to reach the desirable position.
2. Press and hold the memory button 1 until all tree memory buttons turn red.
3. Position 1 is now stored in memory, and the memory button 1 shines red. (See the picture below)
4. Move the
focus potentiometer
at the bottom size of the transmitter to reach the desirable position
2. Press and hold the memory button 2 until all tree memory buttons turn red.
3. Position 2 is now stored in memory, and the memory button 2 shines red. (See the picture below)
7. Move the
focus potentiometer
at the bottom size of the transmitter to reach the desirable position
2. Press and hold the memory button 3 until all tree memory buttons turn red.
3. Position 3 is now stored in memory, and the memory button 3 shines red. (See the picture below)
10. Press shortly the previously stored memory button, so that its light indicator turns off. (No memory
button should be turned on!)
10. Move the
focus potentiometer
to the new desirable position. That is the 4
th
manual focus memory.
11. You have now stored 4 memory positions.
Memorizing 4 focus positions
6.3.1Changing of stored memory position
To save a new focus position on the memory button on which you have already stored one, follow
the steps:
1. Move the
focus potentiometer
at the bottom size of the transmitter to reach the new position.
2. Press a memory button again and hold it until all tree memory buttons turn red.
3. You have now changed previously stored memory position with the new one, and the memory button
shines red.
