4.5 Memory presets
To store desirable memory point, please follow the steps:
1. Turn the head to desired direction using joystick.
2. Press and hold wanted memory button (1-6)
3. All memory buttons will flash red.
4. The desirable position is now stored and can be recalled any time by short press to the memory button.
When recalled, memory button will turn green.
To store another memory point, repeat the steps 1-4. The controller allows the storage of 6 different
memory points.
4.5.1 Replay speed
To change the speed of head moving from one stored position to another, use potentiometer labeled as
R
EPLAY
S
PEED
. Left end position for slowest moving, right end for fastest.
4.6 Auto Memory Recall
After you have stored the desired memory points, you can set the automatic memory recall.
To set memory recall, follow the steps:
1.
Press and hold
Menu
button
(
hold it to the last step
)
and before the system enters the Menu (before
the
Menu
button turns yellow) press memory button on which the first memory point is stored (with
which you would like to start the recall session). Green light on the memory button will turn on.
2.
Now press memory button where the second wanted point is stored. Green light on the first memory
point will turn on, and then on the second memory point (the lights will constantly loop showing the
order of memory recall session)
3.
Repeat the step 2 until you have set all wanted points of memory recall session.
4.
Now you can release the
Menu
button.
5.
Auto Memory recall session is now set.
To activate
Auto memory recall
press the
Menu
button shortly. The head will turn to the first stored memory
point, and then to each next added point and it will stop on the last stored position.
If a point is added to memory recall session by mistake, press that last memory point button again
and the point will be deleted from memory recall session.
You can check the order of your auto memory recall session by tracking the green lights.
4.6.1 Loop cycle
This option allows the head to constantly loop over the stored memory points in the order you have set.
To set loop cycle option, you should follow the steps 1-5 in the charter
Auto Memory Recall,
but pay
attention to set the same memory point as the first and the last in the memory recall session!
Set as described, the head will keep looping as long as you do not move the joystick or press the
Menu
button shortly once again.
* For example:
You want to store the memory points: M1, M2, M3.
To visit all points starting with M1:
M
ENU
B
UTTON
_
HOLD
M1_
BUTTON
,
M2_
BUTTON
,
M3_
BUTTON
M
ENU
B
UTTON
_
RELEASE
The head will go to M1 - M2 - M3 and then it will stop.
