If you don’t want to
change the channel of all panels, please follow this
procedure:
1.
Keep the Wall you want to change the channel to turned OFF.
2.
Follow the steps 1-6 from the instructions above.
3.
Use Stobe/Running buttons to change the option to “Send to New”
4.
Press and hold the Menu button to confirm the request
5.
The display will show counting down (from 30s to 0)
6.
Now turn the panel ON (within this 30 seconds)
7.
The panel will start blinking
8.
Press Menu button once again to confirm.
9.
Display with show “Channel changed”
6.1.6.2.
Change bank
This option refers to the bank of the panel/s. You can use control plate to easily change the bank of the
panels. This is the procedure:
1.
The control plate must be set on the same bank as the Wall/s
you want to effect on.
2.
Press the hold Menu button for a few seconds to enter the
Menu.
3.
Use Stobe/Running buttons to find the option “Change bank”
4.
Press the Menu button to confirm the request
5.
Use Stobe/Running buttons to set the desirable bank number
(1-6)
6.
Press the Menu button shortly to confirm the request
7.
The display with show “Send to ALL” meaning that the bank
of all LightWalls that are turned on at that moment will be
changed.
8.
To confirm the request press and hold Menu button until the
display shows counting down (from 30s to 0)
9.
The panel/s will start blinking
10.
Press Menu button once again to confirm.
11.
Display with show “Finished, exiting”
12.
Bank is changed..
