4.
Getting started
1.
Connect the Wall to the power supply using multicore cable.
2.
Connect the power supply to the mails power.
3.
Turn the power supply on.
4.
Turn the power switch of the control plate on.
5.
The control plate will start establishing wireless connection with panels and the lights will flash on all
buttons.
6.
When the lights on buttons turn off, wireless connection is established and your LightStation system
is ready for use.
4.1. Setting the panel address
In order to be able to control the panel with the light control plate, you need to set the address of the channel.
You can control the whole Wall with one channel or you can split the panels in the Wall on 4 different channels.
The address of the panel shows which channel controls it. To set the address of the panel please open the Wall
coverage to reach the panels. Than press the
Address button
on the back of the panel as many times as needed to
set the channel number as shown in the pictures below:
