Prepared by KM 11/2015
14 Patent pending
14407 Coil Plus Dr, Unit A | Plainfield, IL 60544
www.sennco.com | techsupport@sennco.com
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
1.
Clean the surface of the sensor head’s inside face using an alcohol wipe. Dry with a clean cloth.
2.
Peel the backing off of the shielding and carefully line it up with the edge of the sensor head’s inside face. The v notch will be at the top of
the sensor head and the charging port will be at the bottom.
3.
Smooth down the shielding as you continue to adhere it to the sensor head.
4.
Make sure that the shielding is smoothed down and securely adhered across the inside face of the sensor head.
F. Sensor heads
5.
Peel the backing off of one side of the sensor head adhesive.
6.
Secure the adhesive to the sensor head on top of the shielding. Press firmly for about 15 seconds for a strong adhesive bond.
7.
Place the sensor head on a powered cradle to “wake up” the sensor head.
8.
Two red LEDs on the back of the sensor head will flash indicating that the sensor head is active but not yet monitored by the system.
9.
Clean the back of the device to be protected using an alcohol wipe. Dry with a clean cloth.
10. Plug the micro USB power cable into the charging port on the sensor head.
11. The end of the micro USB power cable is molded to fit snugly in the sensor head’s charging port.
12. Peel the backing off of the sensor head adhesive.
