Prepared by KM 11/2015
18 Patent pending
14407 Coil Plus Dr, Unit A | Plainfield, IL 60544
www.sennco.com | techsupport@sennco.com
815.577.3400 | Toll free 866.736.6261
Mon - Fri 9AM - 5PM CST
VI. Sensor head alarm
A. If the sensor head is out of the “safe zone” sphere created by the bubble makers then the red LEDs on the sensor head will begin to flash.
B. After 1-2 seconds the sensor head will emit an alarm tone that is audible to the person holding the device.
C. The flashing red LEDs and audible tone serve as a polite warning that the device needs to be brought back within the safe zone.
D. If returned to the safe zone within 10 seconds the audible tone and flashing red LEDs will cease. The sensor head will return to flashing
green LEDs indicating it is armed.
E.
If, however, the device is not returned to the safe zone within 10 seconds then the main alarm will be triggered causing it to emit a loud
alarm that is audible throughout the area.
VII. Silencing the Main Alarm
A. If the system alarms check the LCD on the main alarm. It will show which sensor head has triggered the alarm.
B. Insert a recognized DaKey into the main alarm to silence it.
C. Check for the issue which caused the alarm to sound.
D. Make any necessary changes (i.e. reattaching a sensor head).
E.
Repeat steps in part V for configuring the system.
F.
Remove the DaKey.
G. After a less than 5 second delay the system will resume normal operation.
H. Technical support can be reached at 866-736-6261 (toll free), 815-557-4786 (cellular), or techsupport@sennco.com (email).
