22
If a problem occurs ...
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
Problem
Possible cause
Possible solution
Diversity
receiver cannot
be operated,
“
Locked
”
appears on the
display panel
Lock mode is activated Deactivate the lock mode
(see page 10).
No operation
indication
Batteries are flat or
accupack is flat
Replace the batteries or
recharge the accupack
(see page 7).
No RF signal
Transmitter and
receiver are not on the
same channel
Set the transmitter and
receiver to the same channel.
Synchronize the transmitter
with the receiver
(see page 14).
Transmission range is
exceeded
Check the squelch threshold
setting (see page 14).
Reduce the distance between
transmitter and receiver.
RF signal is
deactivated
(“
RF Mute
“)
Activate the RF signal
(see the instruction manual
of the transmitter).
RF signal avail-
able, no audio
signal, “
MUTE
”
appears on the
display panel
Transmitter is muted
Cancel the muting
(see the instruction manual of
the transmitter).
Receiver’s squelch
threshold is adjusted
too high
Reduce the squelch threshold
setting (see page 14).
Transmitter doesn’t
transmit a pilot tone
Deactivate the pilot tone
evaluation (see page 18).
Audio signal has
a high level of
background
noise
Transmitter sensitivity
is adjusted too low
Adjust the transmitter
sensitivity correctly
(see the instruction manual
of the transmitter).
Audio signal is
distorted
Transmitter sensitivity
is adjusted too high
Adjust the transmitter
sensitivity correctly
(see the instruction manual
of the transmitter).
Receiver’s audio
output level is
adjusted too high
Reduce the audio output level
(“
AF Out
”, see page 16).
No access to a
certain channel
During scanning,
an RF signal has
been detected on
this channel and
the channel has
been locked
Set the transmitter operating
on this channel to a different
channel and redo the
frequency preset scan
(see page 15).
During scanning, a
transmitter of your
system operating on
this channel has not
been switched off
Switch the transmitter off and
redo the frequency preset scan
(see page 15).