Putting the devices into operation
13
Attaching the bodypack transmitter to clothing
You can use the belt clip
2
to attach the bodypack transmitter to clothing (e.g. belt, waist-
band).
The belt clip is detachable so that you can also attach the transmitter with the antenna
pointing downwards. To do so, withdraw the belt clip
2
from its fixing points and attach it
the other way round. The belt clip
2
is secured so that it cannot slide out of its fixing points
accidentally.
To detach the belt clip:
#
Lift one side of the belt clip as shown in the diagram on the right-hand side.
#
Press down the belt clip at one fixing point and pull it out of the transmitter housing.
#
Repeat for the other side.
SKM 100 G3 radio microphone
#
Only hold the radio microphone by its body.
Inserting the batteries/accupack
For powering the radio microphone, you can either use two 1.5 V AA size batteries or the
rechargeable Sennheiser BA 2015 accupack.
#
Unscrew the lower part of the radio microphone from the radio microphone’s body
#
by
turning it counterclockwise.
#
Slide back the lower part of the radio microphone as far as it will go.
#
Open the battery compartment cover
-
(see page 14).
#
Insert the batteries or the BA 2015 accupack as shown on the battery compartment
cover. Observe correct polarity when inserting the batteries/accupack (see page 14).
2
If you touch the antenna of the radio microphone during operation, the trans-
mitter’s range will be considerably reduced!
#
When unscrewing the radio microphone during operation, the muting function is
automatically activated. “
MUTE
” appears on the display panel.
When screwing the lower part of the radio microphone back to the radio micro-
phone’s body, the muting is canceled.
ew 100 P G3 Set _529660_0309_Sp9.book Seite 13 Mittwoch, 8. April 2009 6:57 18
