Adjustment tips
19
왘
On the receiver, change to the “
Soundcheck
” standard display.
If no transmitter is being received or if the signal is below the squelch threshold level,
“
MUTE
” appears.
왘
With the transmitter, walk up and down the transmission area.
The receiver records the following parameters and displays them on the “
Soundcheck
”
standard display:
Synchronizing a transmitter with the receiver
When synchronizing a transmitter with a receiver, please observe the following:
Synchronizing a transmitter with the receiver – individual operation
Upon delivery, transmitter and receiver are synchronized with each other. However, if you
cannot establish a transmission link between transmitter and receiver, you have to synchro-
nize the channels of the devices:
왘
With the receiver, perform a frequency preset scan to scan the frequency banks for unu-
sed channels (“
Scan New List
PEAK
-10
0
40
25
10 -20
-30
AF
RF
543.200
ew100 G3
1. 1
MUTE
MHz
“Soundcheck”
standard display
“Receiver Parameters”
standard display
543.200 MHz
Soundcheck
MUTE
PEAK
-10
0
-20
-30
AF
40
25
10
RF
P
AF Max
RF Max
RF Min
Display
Meaning
What to do ...
RF Min
Min. RF signal level:
• must be well above the
squelch threshold level for
one of the two antennas
왘
Check if the antennas and the antenna
cables are correctly connected.
왘
Improve the position of the antennas.
왘
If necessary, use antenna boosters.
RF Max
Max. RF signal level:
• both antennas should reach
40 dB
μ
V
AF Max
Max. audio level
왘
On your transmitter, adjust the audio
level as high as possible without the level
display for audio level showing full
deflection (AF Max is at a level with the
PEAK display).
For more information, refer to the inst-
ruction manual of the transmitter.
왘
Only use a transmitter and a receiver from the same frequency range (see the
type plate on the transmitter and the receiver).
왘
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
왘
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
Summary of Contents for EM 100 G3
Page 1: ...EM 100 Instruction manual ...
Page 29: ......
