Synchronizing the transmitter with an EK 300 IEM G3 receiver
34
Operation without network
왘
Carry out the
Easy Setup Sync
function and then, for each transmitter/receiver pair, the
Sync
function (see page 17).
This establishes a transmission link between the transmitter and the receiver.
Using freely selectable transmission frequencies
You can also freely select the frequencies and store these frequencies in the frequency banks
“
U1
” to “
U6
”.
If you want to use the frequency banks “
U1
” to “
U6
”:
왘
Make sure to use transmitters and receivers from the same frequency range (see page 4
and the type plates of the devices).
왘
Only use frequencies that are approved and legal in your country (see page 33).
왘
Set each transmitter to the same frequency bank.
왘
On one of the transmitters, select a channel within this frequency bank (see page 20).
왘
Assign this channel one of the calculated transmission frequencies (see page 20).
왘
Synchronize a receiver with your transmitter (
,
OR
왘
Manually set the receiver to the same frequency bank, channel and frequency that you set
on the transmitter.
왘
Repeat for the remaining transmitters and receivers as described above.
To ensure that the desired frequencies are intermodulation-free:
왘
