26
Synchronizing the plug-on transmitter with a receiver
Synchronizing the plug-on transmitter
with a receiver
When synchronizing the plug-on transmitter with a receiver, please
observe the following:
Synchronizing the plug-on transmitter with the
receiver – individual operation
Upon delivery, the plug-on transmitter and the receiver are synchronized
with each other. If, however, you cannot establish a transmission link
between plug-on transmitter and receiver, you have to synchronize the
channels of the devices.
For information on automatic synchronization of the plug-on transmitter
with the receiver (individual operation), refer to the instruction manual of
the receiver. This information is marked with the
icon.
Alternatively, you can set the channel on the plug-on transmitter
manually:
왘
Make sure that you set the plug-on transmitter to the same frequency
bank and the same channel as the receiver (see page 20).
If you still cannot establish a transmission link, refer to the chapter “If a
problem occurs ...” on page 29.
왘
Only use a plug-on transmitter and a receiver from the same
frequency range (see the type plates on the transmitter and
the receiver).
왘
Make sure that the desired frequencies are listed in the
enclosed frequency information sheet.
왘
Make sure that the desired frequencies are approved and legal
in your country and, if necessary, apply for an operating
license.
