Adjusting settings via the operating menu
28
Adjusting the transmission power – “RF Power”
Via the “
RF Power
” menu item, you can adjust the transmission power in three steps (Low,
Standard, High).
Activating/deactivating warning messages – “Warnings”
Via the “
Warnings
” menu item, you can activate or deactivate different warning messages.
Adjusting the contrast of the display panel – “LCD Contrast”
You can adjust the contrast of the display panel in 16 steps.
Resetting the settings made in the operating menu – “Reset”
When resetting the settings made in the operating menu, only the selected settings for the
pilot tone and for the frequency banks “
U1
” to “
U6
” remain unchanged. For an overview of
the factory-preset default settings, refer to the enclosed frequency information sheet.
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
It is vital to observe the notes on the enclosed frequency information sheet!
Select the desired
setting
RF Power
Store the setting
Call up “RF Power”
Advanced Menu
Sync Settings
RF Power
Warnings
“Stored”
PEAK
PEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
PEAK
PEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
PEAK
PEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
Standard
Standard
Low
RF Power
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Setting
Warning message with color
change on the standard display
Trigger
AF Peak
“
AF Peak
”
Audio overmodulation
RF Mute
“
RF Mute
”
RF signal is deactivated (see page 14)
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Reset
Select the desired
setting; apply the setting
Advanced Menu
Call up “Reset”
LCD Contrast
Reset
IP-Address
Yes
“Stored”
PEAK
PEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
PEAK
PEAK
-10
0
-20
-30
-40
-10
0
-20
-30
-40
AF
AF
