Quick Opera�on Guide
SENSASOUND USA LLC TPO-7300 User’s Manual 7
For those who want to listen to music or watch movies right away, please follow this quick
guide set forth, to connect and operate your amplifier in the right way to avoid all poten�al
damages.
However, this instruc�on manual contains a great deal of other informa�on that you should
know for the proper opera�on of the amplifier. Therefore, we highly recommend you to read
the rest of this manual as well a�er reading this quick guide.
Below are the quick steps for those of you who want to operate the TPO-7300 right away.
Make sure the system remained powered off un�l all connec�ons are completed, otherwise,
you might encounter undesired sound.
1.Make sure the system remained powered off un�l all connec�ons are completed.
Lower the volume of the preamplifier to the minimum so that when the amplifier is turned
on, you do not hear loud undesired sound.
2.Lower the volume at the preamplifier
Connect speakers to the amplifier using the proper speaker cables. Be sure to match the
channels and the posi�ve (+) and nega�ve (–) polari�es between speakers and the amplifier.
If the connec�ons are mistaken, the correct orienta�on will not be obtained.
3.Connect speakers to the amplifier.
The amplifier possesses a balanced input (XLR) and unbalanced input (RCA) for each channel
and the switch for the two is located between the two input terminals. Select the proper
input type depending on the func�onality of the connected cables and the control amplifier.
4.Select balanced input (XLR)or unbalanced input (RCA) with the INPUT SELECT switch.
The TPO-7300 has a unique home theater mode, which can be waked-up/turned-on
automa�cally when a preamplifier outputs a 12V signal by default. If you do not need this
func�on and want to conceal the amplifier or put it into a separate equipment room using
integrated central control system, make sure switch it to ON. Under ON mode, when you
want to turn on the amplifier, just simply turn on the power switch at the rear panel.
5.Make sure the TRIGGER/ON switch is in the desired status.
