6
3D Systems, Inc
.
3
SENSE SCANNER SETUP
Unpack and set up your scanner and scanner software before you get started with the basics of scanning .
WHAT'S INCLUDED
The box contains the Sense 3D scanner with attached USB cable and the Quick Start Guide .
Remove the scanner from the box and plug the USB cable into your computer .
DOWNLOAD THE SENSE SOFTWARE
Navigate to
http://www .3dsystems .com/shop/sense/downloads
, and follow the instructions to complete the software download and
installation .
RUN THE SENSE SOFTWARE
When you installed the Sense software, a shortcut was created on your desktop . Use the shortcut to open the application .
NOTE: If the scanner is not connected to your computer, a message will state "Device not connected ." Plug the USB
connector for the scanner into the USB port on your computer .
You will then be prompted to activate your Sense 3D scanner .
ACTIVATE YOUR SENSE SCANNER
If you do not have an activation code, click on
Get activation code
. Once you have your activation code, you can enter it into the
activation dialog box . Click
Activate scanner
to complete the activation .
