Processing image data
connect USB cable
to autopilot
•
Step 3 - Prepare data for import:
To import the Drone Flight Log, con-
nect the supplied USB cable to the
swinglet CAM
’s autopilot, marked with
a
icon. Connect the battery to the drone if it is not already connected.
The status LED will become white and a new storage drive will appear on
your computer.
To import images, remove the SD card from the camera, insert it into the
SD card reader of your computer and select ‘Import from SD-card reader’.
Alternatively, transfer the images from the camera by lifting it out of its
compartment just enough to connect a USB cable to it and turn the camera
on. Copy all the images into a temporary folder on your computer. Select
‘Import from a specific folder’ and choose the temporary folder.
•
Step 4 - Import flight logs:
Confirm that the Drone and eMotion Flight
Logs found by the Flight Data Manager are correct. You may select logs
manually if they are not correctly detected.
•
Step 5 - Import images:
Confirm that the images corresponding to your
flight were found and matched to the Drone Flight Log correctly.
45
Summary of Contents for swinglet
