56
CamCor CT and PRO Series Hardware Manual
Section 6
Connections between the Separately-mounted Transmitter and Sensor Models
Terminals for wiring connections with the sensor unit are found on the side of the transmitter housing. Remove the cover
and make the wiring connections as follows:
Using a flat tool, loosen the cover to the right of the transmitter display by turning it counterclockwise, being
careful not to damage the finish. Remove the loosened cover by hand.
Access the terminal blocks and wire the transmitter
to the sensor unit.
C1
J2
NOL
J1-1
J1-2
COUP
Do not move jumpers J1-1 or J1-2 from
their default positions.
Figure 6.2—Wiring procedure for separately-mounted transmitter to sensor unit
POWER SUPPLY LINES AND GROUND TERMINAL
Power source primary lines are connected to terminals L (+) and N (–). (Over-voltage Category II, Pollution Degree 2).
Connect an earth ground only to “GND” on the terminal block or to the external ground terminal (shown in
).
External
ground
terminal
Figure 6.3—Location of external ground terminal on CT Series sensor with integrally-mounted transmitter
CAUTION
Supply voltage must be within the range shown on the product nameplate attached to the housing.
Summary of Contents for CamCor CC001
Page 14: ...14 CamCor CT and PRO Series Hardware Manual Section 3 This page is left blank intentionally ...
Page 24: ...24 CamCor CT and PRO Series Hardware Manual Section 3 This page is left blank intentionally ...
Page 54: ...54 CamCor CT and PRO Series Hardware Manual Section 5 This page is left blank intentionally ...
Page 62: ...62 CamCor CT and PRO Series Hardware Manual Section 7 This page is left blank intentionally ...