11
Section 3
CamCor CT and PRO Series Hardware Manual
3. Lift off the black plastic cap to expose the maintenance board (
). Take care not to lose the spacers between
the circuit boards.
CAUTION The screws holding the plastic cap in place also secure two shock-absorbing spacers positioned be-
tween the maintenance board and the blind board underneath it (
). To avoid damage to the
circuit boards, ensure that the spacers are in place before reinstalling the black plastic cap.
Maintenance
Board
Spacer
Blind Board
Figure 2.5—Maintenance and blind boards, showing location of shock-absorbing spacer
(
1 of 2
)
4. To retain the spacers in the proper position, insert the screws from the black plastic cap into the screw holes on the
Maintenance/Blind board assembly. Do not lift the board assembly from the enclosure.
Figure 2.6—Maintenance board, showing switch and terminal block positions
5. Verify that SW1 (
), which provides power to the maintenance board, is in the “P_ON” position.
Summary of Contents for CamCor CC001
Page 14: ...14 CamCor CT and PRO Series Hardware Manual Section 3 This page is left blank intentionally ...
Page 24: ...24 CamCor CT and PRO Series Hardware Manual Section 3 This page is left blank intentionally ...
Page 54: ...54 CamCor CT and PRO Series Hardware Manual Section 5 This page is left blank intentionally ...
Page 62: ...62 CamCor CT and PRO Series Hardware Manual Section 7 This page is left blank intentionally ...