7
Anti-Calc System
A special resin filter inside the water reservoir softens the water and prevents scale build-up
in the plate. The resin filter is permanent and does not need replacing.
Automatic Shut Off
If the iron is switched on and not moved for a period of 7 minutes while standing on its heel or
25 seconds while standing on the soleplate, an internal safety feature will switch the iron off and
the auto-shutoff indicator will blink. Move the appliance sharply to switch it on again.
Cleaning
• Disconnect the appliance from the mains before cleaning.
• Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.
• The iron has a self-clean button. It is recommended to use this feature to clean the
iron sole plate steam holes.
• To operate ensure that the water tank is full and set the temperature control dial to it’s
maximum setting. When the temperature ready light goes out, unplug the iron and hold it
over a sink. Hold down the self- clean button. Strong bursts of steam will come from the
base of the iron bringing with it any debris which has built up. Alternatively the above can
be carried out over an old cloth.
Troubleshooting
IRON EMITS AN ODOUR OR SMOKE
Iron gives off an odour when turned on for the first time. Oils used during manufacture need
to be burnt off. Allow ten minutes for the odor to disappear.
IRON DOES NOT HEAT
The temperature control dial must be set at the desired temperature.
IRON DOES NOT STEAM
The water tank may be empty. Turn the steam regulator to “0” and add water. Allow the iron
to heat, and then set the steam dial to the steam setting.
STEAM BURST FEATURE DOES NOT WORK
The water tank must be at least 1/4 full. Temperature must be set to steam position. Iron should
be in the horizontal position. Prime pump briefly. Allow a short pause between shots. Be sure to
fully depress the steam burst button.
IRON IS LEAKING
The temperature setting is too low to produce steam. Steam burst used too much,
allow iron to re-heat.
