background image

SLDY0014W  

 

2 / 4 

www.senslights.com

 

Email:

info@senslights.com

 

 

 

 

Working time 

8-10hours,battery capacity providing 2- 

3continuous cloudy or rainy days backup 

Temperature Range 

-40 -- +60 Degree 

Protection 

IP44 

No Wiring …. No electricity!

 

 

Location of the Solar Light

 

 
 

1)

 

The  solar  light  must  be  located  in  a  position  where  it  can  get  direct 

sunlight  on  the  solar  panel,  and   generally   free    from    cover    and 

shade.  When   locating   a   suitable   position   for   the   unit,  remember 

that  it  detects  an  area  of  about  45-60  degrees  vertically  and  about 

90-120  degrees horizontally, with a range of over 5 meters. 

2)

 

The  solar  light  must  be  left  to  charge  for  2  sunny  days  before  first 

time use so that best results are achieved. 

Assembly Instructions

 

 

 

Lamp installations

 

 
 

 

1)

 

Choose the wall you want to set and signed with the 4 holes. 

2)

 

Burrowed with Inflatable Screws on the 4 holes. 

3)

 

Hang the lamp onto the wall base plate . 

Summary of Contents for SLDY0014W

Page 1: ...l 3 5W high efficiency Polycrystalline PV module Battery 1PC Ni Mh 2000mAh batteries maintenance free Controller Intelligent controller light time intelligent control waterproof IP 44 guard level various protections over charge and over discharge protect function Lumen 200lm LED Source 12 pcs 0 2w LEDs high brightness LED LED Type φ 0 3w LED colors white Average Life hrs 35000 Average operation ti...

Page 2: ...solar panel and generally free from cover and shade When locating a suitable position for the unit remember that it detects an area of about 45 60 degrees vertically and about 90 120 degrees horizontally with a range of over 5 meters 2 The solar light must be left to charge for 2 sunny days before first time use so that best results are achieved Assembly Instructions Lamp installations 1 Choose th...

Page 3: ...riod your solar lights are ready for use Your light will now function automatically Replacing the Batteries 1 Take off the 4 screws with screwdriver and replace the old Ni Mh batteries Make sure the new batteries are Ni Mh rechargeable batteries 2 Install the new batteries in to the battery compartment ensuring the correct polarity is observed 3 Reassemble the unit by reversing the above procedure...

Page 4: ...in the shade during the day 3 Make sure the switch is in the auto position 4 Check that the batteries are installed correctly Maintenance Clean the solar module regularly with a damp towel to guarantee optimum performance of the solar panel Do not use any type of solvent for cleaning and be careful not to put too much pressure on the module while cleaning If you need any support please contact sup...

Reviews: