8
Operation
Grabber Operation
Press the switch forward to close the tool jaws. When the jaws
have tightened fully, the status LED will change to
Yellow.
Press the switch rearward to open tool jaws.
Changing Jaw Sets
To change the preferred jaw set on tool, use a 3/32-inch hex key
to remove the socket head screws on each jaw.
Slide each jaw off the tool and clean the interfacing surfaces.
Slide preferred jaw onto tool and install socket head screw.
Battery Status
Press the switch to the left to display the battery condition on the
status LED.
100% - 3 Green blinks
80% - 2 Green blinks
60% - 1 Yellow blink
40% - 1 Red blink
20% - 1 long Red blink
Power Saving Modes
After 10 minutes of no switch activity, the system will dim the
video display. The status LED will blink Blue. Moving the switch
will awaken the system.
After 20 minutes of no switch activity, the system will sleep using
a small amount of battery power. The status LED will blink
Blue. Moving the switch will awaken the system.
After 30 minutes of no switch activity, the system will completely
shut down and use no power. See Powering the System to
restart.
