Neon Family
User Manual
Sensormetrix is a division of Sequoia Technology Group Ltd
Registered in England No. 4004881
VAT Registration No. GB614 5653 45
Sensormetrix
sales
+44 (0) 845 451 2021
Basingstoke Road
fax
+44 (0) 118 976 9020
Spencers Wood
sales@sensormetrix.co.uk
Reading
web
www.sensormetrix.co.uk
Berkshire RG7 1PW
Page 11 of 39
Note that after the changes to the password are saved, the password box is blanked out so that the entered password
cannot be seen. This means that an entered password cannot be edited – it must be entered in full again if a change is
required.
If the user name and/or password are forgotten, the only way to recover the unit is to do a factory reset. Please make a note
of any important configuration settings before doing this so that they can be re-entered.
Network Page
The network page allows the networking settings for the unit applied and reviewed. Once the settings on this page have
been entered, they should be stored in the unit by clicking the save changes button. Clicking the save changes button
applies the new settings immediately – If manual settings have just been applied they are immediately usable; if DHCP has
been set then the address request to the DHCP server will be made immediately. Any invalid fields are highlighted in red
and will not be saved – correct them and save the changes.
Important:
Sensormetrix recommends using DHCP for networking as this allows appropriate network setting to be assigned
to the Neon automatically by the DHCP server. Please view the application information section of this user manual for
advice on how to fix the units IP address while using DHCP.
Important:
Remember to click the Save Changes button if changes have been made to this page before navigating away
from this page.
Important:
Although the Neon applies network changes immediately, this does not mean that any routers in the system will
be aware of these changes immediately. It is recommended that the Neon be rebooted after making any changes to the
networking properties. This can be done by cycling the power to the unit, or by initiating a reboot from the Info page.
Important:
If the network settings are changed, the IP address used to view the Neon’s web server will most likely change
causing an error viewing the web page. Please allow 10-15 seconds for the Neon to reboot and the network to adjust to the
change before reconnecting to the unit at its new address.
