Sentinal DTS Quick Start Guide SEN2-QSG1.0
Page 7
4.
START MEASURING USING THE SENTINEL DTS
Once the connections shown in section 2 have been made, the Sentinel DTS is
ready to use. Before operating the Sentinel DTS, ensure all users have read and
fully understood the safety section of this quick start guide.
LAUNCHING THE SENSORNET SENTINEL DTS SOFTWARE
Turn on the Sentinel DTS system by switching the power isolation switch on the
rear panel to the ON position. The Sentinel DTS is configured to automatically load
and run the DTS measurement software. However if the software is not running
once the operating system has loaded, double click on the Sentinel DTS Icon as
shown in Figure 3 or alternatively click on Start / Programs / Sentinel DTS.
Figure 3 - The Sensornet DTS Software Icon.
NOTE:
Hardware Initialisation may take up to 60 seconds to perform.
Once the hardware has initialised, the Sensornet DTS Sentinel Main Menu will
appear as shown in figure 4.