Universal digital display AZ12
25
Configuration / operating of Function keys
Documentation for routing diagram
In general:
When configuring the display you are guided through all parameters,
you can choose the settings which fit the application. For each menu
there is a scrolling help text which is automatically shown in the
display. This starts after 5 seconds if no key has been activated.
Configuration is carried out by using the 3 function keys.
If a function does not exist in the display all parameters are skipped to
make the configuration as simple as possible.
Once the configuration has been entered the display will show
„----“
Pressing and holding OK – will return to the previous menu or return
to the default state (1.0) without saving the changes values or
parameters.
If no key is activated for 2 minutes, the display will return to the
default state (1.0) without saving the changed values or parameters.
Further explanations:
Fast setpoint adjustment and relay test:
These menus allow you to change the setpoint quickly and to check the
operation of the relay.
Pressing
and
at the same time willchange the state of the relays – this change
is indicated by the diodeson the display.Pressing OK will save the stepoint change.
Holding down OK for more than 5 seconds will return the unit to the default state
without changing the setpoint.
Will increase the numerical value or choose
the next parameter
Will accept the chosen value and end the
menu
Will decrease the numerical value or choose
the previous
parameter
