The Senstar 100 Startup program
3 - 2 • • • Senstar 100 Installation guide
The Senstar 100 Startup program
The QNX4 boot disk contains the Senstar 100 Startup program.
The Startup program is used to:
•
initialize the hard disk and load the QNX4 OS
•
load the Senstar 100 application software onto the hard disk
•
update the OS
•
load the Senstar 100 sample site data onto the hard disk
•
load additional QNX licences (network applications)
•
make backup files of the software and data floppy disks
•
format floppy disks for use with the Senstar 100 system
•
select and align the touch screen
•
select the keyboard character set
•
select the graphics card and the number of monitors defined in the site data
•
test the MFC
•
copy user-data from the hard disk to a floppy disk
•
change the site data or computer node ID
Running the Startup program
1. Ensure that the computer is turned OFF.
2. Insert the QNX boot disk into the floppy drive.
Leave the boot disk in the floppy drive until you are prompted
to remove it.
3. Turn ON the computer.
After the BIOS and memory checks, the computer should attempt to boot
from floppy disk. The QNX OS boots, and the
Senstar 100 Startup Program
menu displays.
