Initializing the hard disk
Senstar 100 Installation guide • • • 3 - 9
Copying files from floppies to hard disk
1. Press
Enter
to begin copying the files.
2. Remove the boot disk.
3. Insert the QNX license key in the floppy drive.
4. Press
Enter.
5. When prompted, insert the QNX operating system disks.
6. Press
Enter
to copy a floppy disk to the hard disk.
7. When copying is complete, remove the operating system disk.
8. Insert the boot disk into the floppy drive as prompted.
9. Press
Enter
.
Making QNX boot from the hard disk
1. Press
Enter
to begin the procedure.
The following table summarizes the information that the program prompts
you to enter:
2. Because the system requires 32-bit drivers, cancel the prompt to make 16-bit
drivers (the default) by pressing
Enter
.
3. Type the unique QNX network node number when prompted.
The default node number is
1
.
4. Press
Enter
.
5. When prompted, press
Enter
to copy the files.
6. When prompted, press
Enter
to continue copying files.
Parameter
Selection
default drivers
32
node #
___ (unique network ID required for each Senstar 100 CU on the
QNX network, i.e., default node # = 1)
time zone
___ (from the list, select the time zone in which the system will
operate)
real time clock
g (select Greenwich Mean Time for the real time clock)
consoles
4
mouse
no (this selection applies only to the QNX operating system and
does not affect the use of a mouse under Senstar 100 operation)
network
no (network setup is handled separately, outside of the QNX
installation program)
