Hardware setup
4 - 2 • • • Senstar 100 Installation guide
Hardware setup
You can use the
F6
Setup Hardware function to select and configure the
secondary devices connected to the Senstar 100 CU.
Displaying the Select Hardware menu
1. Press
F6
.
The
Select Hardware
menu displays.
You can use the
Select Hardware
menu to set up the peripheral devices for your
Senstar 100 CU.
F1
Select Graphics Card and Number of Monitors
F2
Select and Align Touch Screen
F3
Select Keyboard Type
F4
Set Active Boot Partition
F5
Switch Active VGA Port on WARP Card
F12
Exit Select Hardware
Select Hardware
Press a function key to make a selection
>
VGA MASK 4.03
Version 6.12