Installing a QNX network
Senstar 100 Installation guide • • • 4 - 23
Senstar 100_netmon.exe for ARCNET
Previously, on certain systems the QNX Net.arcnet driver failed initialization with
codes 18, and sometimes 4 (
netinfo -a |
further explains the error codes). As a
result, a special process called
s100_netmon.exe
was developed to dynamically
load the CPU and initialize the card, during the initialization process, in order to
prevent these failures. This program is available in Senstar 100 software version
6.05 and higher. To use this process, add the following line to the
sysinit
file
instead of the line that starts the Net.arcnet driver:
/exe/s100_netmon.exe 20 23 1 &
