Copyright ©POWERCOM CO., Ltd
13
5.5 Замена батарей
Ниже приведена пошаговая инструкция по замене батарей:
Рис. 5.
Замена батарей
1. Снимите переднюю панель
Передняя панель снимается путём нажатия на место, обозначенное стрелкой на рисунке.
2. Открутите винты и снимите металлическую заглушку
3. Отсоедините провода и вытащите батареи
4. Замените батареи и установите их обратно в ИБП
5. Установите металлическую заглушку и переднюю панель
5.6 Параметры по умолчанию, установленные изготовителем
В ИБП предусмотрено несколько параметров, которые можно установить с панели управления. Изготовитель
устанавливает следующие значения параметров:
Параметры
Варианты выбора
Заводские установки
Выходное напряжение
208/220/230/240 В
230 В
Выполнить тест АКБ
On/Off
Off
Ручной байпас
On/Off
Off
Режим высокой эффективности
On/Off
Off
Режим свободной генерации
On/Off
On
Режим Генератора
On/Off
Off
Отключение сигнализации
On/Off
Off
Изменение установленных по умолчанию значений параметров рекомендуется выполнять после завершения
установки, но до подключения оборудования к ИБП.
См. раздел 7.2 (Конфигурация ИБП).
6 П
ОДКЛЮЧЕНИЕ К КОМПЬЮТЕРУ И СИСТЕМЕ СИГНАЛИЗАЦИИ
Интерфейс для прямого подключения компьютерной системы находится на задней панели ИБП (расположение
интерфейсного порта показано на
Рис. 2
). В стандартный комплект ИБП входят один кабель последовательного
интерфейса RS-232, один кабель интерфейса USB (опция). Порт RS-232 нельзя использовать одновременно с портом
USB, при этом USB имеет приоритет перед RS-232.
ИБП оснащён слотом дополнительного интерфейса, в которое можно установить различные коммуникационные платы.
Платы, установленные в этот слот, могут работать одновременно с портом USB или RS-232. Для установки в слот
дополнительного интерфейса предназначены две платы:
а) плата SNMP, обеспечивающая контроль и управление по компьютерной сети или через Интернет;
б) плата AS-400, содержащая реле с изолированными контактами.
Дополнительную информацию об этих платах можно получить у поставщика оборудования.
Summary of Contents for SNT-1000
