10
©
All rights reserved. All trademarks are property of their respective owners.
Tower Display
This mode designs for highly unstable power. In this mode, UPS normal operation
will not transfer to bypass to prevent load damage and frequent battery discharge. UPS
will also fix output frequency to 50Hz(220V) or 60Hz(110V) with ±0.25Hz. Users can set
the UPS to bypass/shutdown whenever UPS malfunction occurred.
Generator Mode can activate from the LCD panel too.
4.2 System Configuration
The UPS device and battery make up the system. Depending on site and load
requirements, certain additional options are available as tailored solutions. Please
consider the following when planning your UPS system:
The total demand for the protected system shall dictate the output power
rating (VA). When measuring demand, please allow a margin for future
expansion and calculation error.
Battery-mode duration needs dictate the battery size. If the load is less than
the UPS nominal power rating, then the actual backup time is longer.
The following options are available:
Connectivity options (Relay card, SNMP/WEB card)
External battery packs
Transformer cabinets
Maintenance
bypass switches
4.3 Panel overview
Rack Display
Summary of Contents for SNT-1000
