The Server Technology Inc. Sentry family of products provides easy, practical, and secure solutions for
power distribution, power management and load-measurement for remote internetworking equipment
and branch AC circuits.
The
Sentry Power Distribution Unit
(PTPD) provides simple power distribution with cumulative load
monitoring for environments without a requirement for remote power management.
Features and Benefits
Sentry Power Distribution Units are available in 8-outlet, 16-outlet and 18-outlet configurations for
100-120VAC or 208-240VAC up to 30A. See
Power Distribution
A Sentry Power Distribution Unit distributes a maximum of 30A AC power (dependant on PTPD
model) across a maximum of sixteen attached devices.
Load Measurement
The Sentry Power Distribution Unit’s load measurement feature eliminates guesswork by supplying the
cumulative operating load in amperes. This allows on-site technicians to maximize the equipment
installed and operated on a circuit without worry. Use of the circuit is maximized, while effectively
allowing a 10% to 20% safety margin. Remote users also may access this information at any time from
the Control Screen interface (Remote access not available on PTPD-xE models).
Over-Threshold Notification
Sentry Power Distribution Units features two standard over-threshold alarms; an audible alarm for the
local technician and a contact-closure alarm circuit which allows over-threshold alerts to be sent a third
party device (Not available on PTPD-xE models).
Technical Support
Server Technology understands that there are often questions when installing and/or using a new
product. Free Technical Support is provided from 8:30 AM to 5:00 PM, Monday-Friday, Pacific Time.
See
in Warranty, Product Registration and Support for more information.
Server Technology, Inc.
1040
Sandhill
Drive
Tel: 775.284.2000
Web: www.servertech.com
Reno, Nevada 89521 USA
Fax: 775.284.2065
Email: support@servertech.com
Quick Start Guide
The following instructions will help you quickly install and configure your Sentry Power Distribution
Unit for use on your network. For detailed information on each step, go to the page number listed to
the right.
1. Review
all
safety notices............................................................................................................5
2. Verify input voltage selection
(PTPD-VE18 models only)
.......................................................15
3. Mount the Sentry Power Distribution Unit.................................................................................5
4. Connect to the power source ......................................................................................................6
5. Connect the devices to the Sentry Power Distribution Unit .......................................................7
6. Configure the Sentry Power Distribution Unit
(PTPD-x0 models only)
.....................................9
Configure location ............................................................................................................10
•
•
Configure overload threshold ...........................................................................................10
7. Connect to the Sentry Power Distribution Unit..........................................................................7
2
•
Introduction
Sentry Power Tower Power Distribution Unit
Installation and Operations Manual